table socket, 3-part, cable length: 1,5m
Product number:
13911
Product information "table socket, 3-part, cable length: 1,5m"
Warnings
This table power strip is intended for indoor use only. It must only be used in dry environments, especially during fencing events. Ensure that the power strip does not come into contact with moisture, sweat, rain or cleaning agents during operation. Otherwise, there is a risk of electric shock or short circuit.
Before each use, inspect the device for visible damage to the housing, cable or sockets. Do not use the power strip if it shows any signs of damage.
Do not exceed the maximum rated power specified by the manufacturer. Overloading may result in overheating or fire hazards.
Do not connect this power strip in series with other power strips. Daisy-chaining can lead to dangerous overloading.
Avoid kinking, crushing or running the cable over sharp edges. Damaged cables can cause electric shock or fire.
During use in fencing environments, ensure the power strip is positioned safely, so that it does not pose a tripping hazard and cannot be accidentally moved or damaged by fencers, referees or spectators.
Never unplug the power strip by pulling on the cable. Always disconnect it by gripping the plug housing to prevent damage.
If you notice sparks, unusual heat or sounds, immediately disconnect the power strip from the power source and discontinue use.
This power strip is not a toy and must be kept out of reach of children. There is a risk of fatal electric shock.
After use, store the power strip in a dry, dust-free location and avoid any mechanical pressure. Pay special attention to ensure the cable is not crushed or twisted.
In case of doubt or technical problems, consult a qualified electrician. Unauthorized repairs are prohibited and dangerous.
Caring and storing instructions
Before any cleaning, disconnect the power strip from the mains. The plug must be removed from the socket, even if connected devices appear to be switched off. Only use dry or slightly damp lint-free cloths for cleaning. The power strip must never be immersed in water or sprayed with liquids.
Do not use aggressive cleaning agents, solvents or abrasive substances, as these may damage the housing or impair electrical hazards.
After cleaning, the power strip must be completely dry before being plugged in or reused.
Regularly check the condition of the housing, sockets, supply cable and plug for dirt, mechanical damage, or signs of wear.
If necessary, mechanical contacts (e.g. retaining springs in the sockets) may be inspected and serviced by a qualified electrician.
Store the power strip in a dry, clean and well-ventilated area, away from moisture, dust, direct sunlight and frost.
During storage, the power cable must not be sharply bent, twisted or crushed. Ideally, coil the cable loosely.
Do not place or stack heavy objects on the power strip to prevent deformation of housing or damage to the cable.
Before reuse after prolonged storage, inspect the power strip again visible defects and verify its functionality.
Uhlmann Fechtsport GmbH & Co. KG
Uhlandstr. 12
D-88471 Laupheim
tel. +4973929697-0
info@uhlmann-fechtsport.de